PDF Nexus 3000
SINGLE PARAMETER VISUALIZATION
The large display enables viewing all the operational parameters. Nexus 3000 can manage one of the following parameters: pH, Rx, Conductivity, Amperometric chorine, mA input for potentiostatic probes, and flow rate. The following two versions are available:
- Wall mounting: 144 x 144 (IP65 protection degree)
- Panel mounting: 96 x 96 (IP65 protection degree for front section and IP20 for rear section)
PROBE WASHING Nexus 3000
Possibility to set the Relay2 output to activate the washing function, based on the three different phases: probe washing, delay time for measure stability and activation interval. The probe washing process can also be set in automatic mode.
GUIDED CALIBRATION Nexus 3000
This procedure allows to monitor all the phases and guarantee the best probes quality for an optimal measure alignment.
ON-OFF / TIMED / PROPORTIONAL RELAY ACTIVATION
The Relay output can be set in three different modes: On- Off, timed and proportional activation, for a right compromise in the management of the chimical parameters during the process.
ANALOGUE AND DIGITAL OUTPUTS Nexus 3000
Nexus 3000 is equipped with 2 relays, controlling the set point and the probe washing, temperature measurement, alarms control, a 4/20 mA analogue output and a frequency output. When setting the instrument, the installer can choose the most suitable configuration for the equipment.
TEMPERATURE COPENSATION
Thanks to a temperature probe it is possible to visualize the current value and make a temperature compensation of the measured parameter within the envisaged values.
EVENTS AND ALARMS Nexus 3000
The display enables viewing the chronology of the events registered by the instrument. The alarms list can be reset at any time.
DIMENSIONS Nexus 3000
WALL MOUNTING VERSION (144 x 144 x 122,5 mm.)
PANEL MOUNTING VERSION (96 x 96 x 42 mm.)
